C&K systems ST800L+ Installationshandbuch

INSTALLATIONMANUALSECURIT 800L+ CONTROL PANELWith additional options

9CIRCUIT PROGRAMMING 4 (Range 2-7)Circuits 2 - 7 can be reprogrammed to suit your requirements. Circuit 1 isfixed as a Final exit circuit. Circuit 8

10ENGINEER ACCESS CODE 1-1The engineer access code is programmed to 7890 by default. To changethis code (while in engineering mode):1. Enter 1-1. LED

11FACTORY PROGRAMMING DEFAULTS 9-9Restoring programming Defaults.Enter 9-9, The sounder will give a rapid pipping sound, wait for 5 seconds, anaccept

12ENTRY CIRCUITThis will start the entry timer when activated providing the panel is set.FIRE (for use with smoke detectors etc.)A zone that when act

13THIS INFORMATION SHOULD BE KEPT EITHER INSIDE THE CONTROL PANEL ORWITH THE INSTALLER. IT CAN BE USED TO REFER TO PROGRAMMING DETAILSWHEN NEEDED.ZON

14FAULT FINDINGA selection of common known problems and solutions are listed below.Problem Cause AnswerProgrammed 7-5 but zone1 will not isolate in ni

15Wiring DiagramPlease Note:IntelliSense are always endeavouring to improve quality and specification of all its productsand may alter or amend this p

1CONTENTSWarnings 2Standards 2Warranty Statement 2Product Description 2Available Parts 2Intended use 2Specifications 3Processor Version 3Power Supply

2WARNINGSProlonged short circuit of any supply can cause damage to the unit. Take the necessaryprecautions in not allowing liquids to spill on or int

3SPECIFICATIONS SPECIFICATION FOR SOFTWARE REVISION NUMBER V3.0The software revision number is located on the top of the main processorPower SupplyM

4INSTALLATIONLocate the control panel out of sight, such as in a hall, under stairs or in acupboard where connection is easy and the detector zone an

5Detector reset (L+ when programmed for ID)Some detectors require the removal of power to reset (e.g. Viper Plus® orSmoke detectors). The L+ terminal

6MOUNTING A REMOTE KEYPAD1. Choose the keypad location and then mark the holes for mounting.2. Make sure the cable is run through the backbox.3. Screw

7To enter engineering mode, enter the engineering code and then press the #(HASH) key. This forces the panel into engineering mode Note: If leftunatt

8SOUNDER DURATION (sounder ring time) 3-2 (Range 3-20 minutes)Enter 3-2. A new time can be programmed by entering a key fromthe table.Enter 1 3 min